Tuesday, October 30, 2018
A launch valve on an 80 year old pipeline was showing its age and needed to be replaced.
Thursday, August 23, 2018
Many comments were made about how much simpler this method was than conventional means.
Wednesday, May 16, 2018
A small leak is no small matter. A hinge pin on a check valve had a minor leak that needed to be addressed.
Thursday, December 7, 2017
Integral is pleased to anounce that Enbridge has been added to the growing list of pipeline operators who have utilized the IsoTool.
Thursday, September 21, 2017
The client approached Integral about utilizing the IsoTool to provide isolation of a 20” condensate pipeline.
Friday, June 2, 2017
In a single pig run the 12” IsoTool isolated both the launch and receive traps to allow for 19 new valves to be installed.
Friday, May 26, 2017
Integrals 18” IsoTool provides isolation for a leaking trap valve.
Friday, May 26, 2017
Configuring the IsoTools to allow for bi-directional travel often provides a smart option when replacing leaking trap valves.
Tuesday, February 21, 2017
The Department of Transportation decided to relocate a bend in an Interstate that had frequent fatalities.
Friday, December 16, 2016
IsoTool™ Performs first IsoPurge™
Friday, August 26, 2016
A 24” receiving trap valve with a known leaking stem needed to be replaced.
Thursday, August 18, 2016
A section of 20” with a known anomaly required removal for verification of the defect.
Tuesday, May 31, 2016
Configured to be bi-directional, the Integral IsoTool was used to isolate a 10” pipeline launcher in North Dakota.
Tuesday, October 13, 2015
Successful 24” pipeline isolation in Cushing Oklahoma using The IsoTool.
Tuesday, October 6, 2015
Integral Pipeline Technologies is pleased to announce a successful 16” pipeline isolation using The IsoTool.